Remote Control - Novy 840029 Mode D'emploi

Remote control

1) lighting cooking mode on/
2) increase speed levels
3) decrease speed levels
4) switch on / off
5) Novy-button: lighting
The remote control for hood is preinstalled and ready
for use.
Change the code on the remote control
If the set code disrupts other transmitters, another
code can be selected using the remote control. There
are 10 different codes.
Determine the code used
Simultaneously press
remote control flashes as many times as the selected
code (there are 10 code options in total).
Change the code (exception Cloud 230, Mood 7550)
• Simultaneously press
• The lamp on the remote control flashes as many
times as the selected code. Repeat this step until
you have reached the required code (there are 10
code options in total).
• Simultaneously press on the cookerhood
until the second green Speed indicator lamp is blin-
king.
• Press the key on the remote control within 10 se-
conds to confirm the settings. The cooker hood and
the remote control are now in line with each other.
Change the code Cloud 230, Mood 7550
• First switch off the power supply of the hood. This
is done by first switching off the power supply of
the hood and then switching it on again. The setting
mode will now be active for 3 minutes. The new fre-
quency must be set within these 3 minutes.
• Simultaneously press
mote control flashes as many times as the selected
code. Repeat this step until you have reached the
required code (there are 10 code options in total).
off
mood mode on/ off (when
available)
and .The lamp on the
and .
+
and . The lamp on the re-
• • Press the key on the remote control within 10
seconds to confirm the settings. The cookerhood
and the remote control are now in line with each
other
Change the batteries:
• For changing the batteries unscrew the plastic co-
ver, remove the old batteries and insert the new
ones. Pay attention to the polarity marking given in
the battery compartment (figure 4).
• Empty batteries are not to be disposed of in the
household refuse, but they are to be handed in as
chemical waste.
Technical information:
• Power supply: (2xAAA) batteries
• Frequence: 433.92Mhz
• Numbre of codes: 10
• Worktemperature: 0-50°C
• Dimensions: 110 x 50 x 19mm
EN 5