Danby DKC054A1BSLDB Guide D'utilisation Et D'entretien page 18

Masquer les pouces Voir aussi pour DKC054A1BSLDB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
PROBLEM
The unit does not operate •
Turns on and off
frequently
Vibrations
The keg cooler seems to
make too much noise
The door will not close
properly
Excessive beer foam
Weak beer fl ow
Danby Consumer Care: 1-800-263-2629
Not plugged in
The circuit breaker tripped or blown fuse
The room temperature is hotter than normal
The door is open too often
The door is not closed completely
The temperature control is not set correctly
The door gasket does not seal properly
The unit does not have proper clearance
Check that the keg cooler is level
The rattling noise may come from the fl ow of refrigerant, which is
normal
Gurgling, caused by liquid refrigerant cycling is normal
Contraction and expansion of the inside walls may cause popping
and crackling noises
The keg cooler is not level
The keg cooler is not level
The door was reversed and not properly reinstalled
The gasket is dirty
The shelves or stand are out of position
The keg is not properly centered in the unit
The casters are not attached
Ensure the beer line hose from the tower and the CO
from the CO
regulator are attached to the correct connections on
2
the coupler; beer line to the top of the coupler, CO
side of the coupler
Check that there are no leaks in any connections
Ensure that the reed valve in the CO
has a hole in it
The CO
pressure may be set too high; try turning the pressure
2
down
Ensure that the valve spool plastic rod is inserted into the coupler
Ensure the beer line hose from the tower and the CO
from the CO
regulator are attached to the correct connections on
2
the coupler; beer line to the top of the coupler, CO
side of the coupler
Check that there are no leaks in any connections
Ensure that the reed valve in the CO
has a hole in it
The CO
pressure may be set too low; try turning the pressure up
2
Ensure there are no bends or kinks in any of the hoses that could
impede fl ow
15
POSSIBLE CAUSE
connection at the coupler
2
connection at the coupler
2
air line hose
2
air line to the
2
air line hose
2
air line to the
2

Publicité

Table des Matières
loading

Table des Matières