Using The Converter - Dometic GROUP Waeco PerfectCharge DC08 Instructions De Montage Et De Service

PerfectCharge/PerfectPower
8

Using the converter

You can switch on the device as follows, depending on the connection:
 Using the main switch on the device (fig. 1 6, page 3)
 Using the ignition (fig. 5 A, page 4)
Terminal 15: Connected positive terminal
 Using an external switch (fig. 5 B, page 4)
Switching on the converter
➤ Set the main switch (fig. 1 6, page 3) on the back of the converter
to "1" ...
... or start the ignition ...
... or push the external switch.
✓ The LEDs (fig. 1 3 to 5, page 3) indicate the operating status:
LED
Power On
Battery Low
Overload
I
NOTE
The internal fan is operated according to the temperature. It only
runs when the temperature is too high. During this time the con-
verter is switched off to prevent overheating.
EN
Colour Explanation
Green The device is switched on and there is volt-
age at the output terminals on the con-
verter. The converter is ready for use.
Yellow The input battery is no longer sufficiently
charged.
➤ Recharge the battery or use a charged
Red
If a consumer is connected:
The converter is shorted or overloaded.
➤ Eliminate the short circuit or reduce the
If connected as a charger:
The converter is in the full current charging
phase.
Using the converter
battery.
output load.
33