Bartscher Slim-Line 80L Mode D'emploi page 28

•
The primary temperature is pre-set at the factory, and is set to ensure a working
temperature range of approx. 2° -10° C.
•
To change temperature settings, proceed as follows:
Press
Press
Press
If no button is pressed within the next 10 seconds, the internal temperature will
appear on the digital regulator display.
NOTE!
To make further adjustments or changes to parameters, contact a sales agent or
assign the work to a qualified service technician.
Lighting
•
The device is equipped with 2 LED lights. They are located at the front of the door
frame, in the centre of the device.
•
Press „ " for one second to turn the device's lighting on. By pressing „
second time, the lighting will be turned off.
LED control lights
LED compressor control light (cooling):
The control light comes on during cooling, goes off when the temperature inside
the chamber is stable, and flashes when there is a delay in activating the cooling.
LED defrost control light:
The control light comes on during defrost, goes off when defrost is completed, and
flashes when there is a delay in the defrost process.
Automatic defrost
The device automatically defrosts 4 times every 24 hours.
to display the current temperature.
or to adjust the temperature.
to complete setup and display the internal temperature.
" a
- 27 -