Chicco Polly Swing Up Mode D'emploi page 24

VIBRATION BLOCK
25. The swing is fitted with a vibration block (Diagram F3) which
can be activated by turning the knob to the "I" position. The
vibration block runs on 1 x 1.5 volt LR20-D battery.
REPLACING THE REMOTE CONTROL, SIDE FIXTURES AND
VIBRATION BLOCK BATTERIES
26. To replace the remote control, side fixture and vibration block
batteries; remove the screws from the various battery compart-
ment covers (Diagrams 15 and 16). Fit the new batteries making
sure they are fitted with their poles in the right direction. Now
replace the compartment covers and firmly tighten the screws.
FOLDING AWAY AND TRANSPORT
The swing can be folded up to store or transport it.
27. Press the side buttons on the X and Y fixtures and close the
frame by pulling the front and rear legs towards each other.
(Diagram 17)
WARNING: Never use the sun hood to carry the swing.
FOR FURTHER INFORMATION:
ARTSANA UK Ltd.
Prospect Close - Lowmoor Road
Industrial Estate - Kirby in Ashfield
Nottingham NG 17/7 LF – England - U.K.
Tel. +44 1623 750870 (office hours)
www.chicco.com
24