Bosch MaxoMixx MSM8 Série Mode D'emploi page 11

Fig.

Place bowl on a smooth and clean work

surface.
Insert blade/kneading hook.

Add food.

Warning!
Blade/kneading hook must be upright in the
bowl so that the lid fits correctly (Fig.=
Place lid on the bowl and turn all the way

anti-clockwise.
If there are larger quantities of ingredients
in the bowl, it may take a little more effort
to attach the lid. If required, turn the three-
winged coupling on the underside of the lid
into the correct position.
Place the base unit on the attachment and

lock into position.
Insert pusher.

Insert the mains plug.

Hold the base unit and universal cutter

firmly and switch on the appliance
(turbo speed).
To add more ingredients, release

the On button. Wait until the tool comes
to a standstill.
Remove the pusher and add ingredients

through the feed tube.
Release the On button after processing.

Carrier disc with disc inserts
Slicing attachment – coarse
Set speed control to low speed for cutting:
cucumbers, carrots, potatoes.
Slicing attachment – fine
Set speed control to low speed for cutting:
cucumbers, carrots, beetroot, zucchini.
Shredding insert – medium
Set speed control to high speed for shredding:
apples, carrots, cheese, cabbage.
Grating disc insert – coarse
Set speed control to high speed for grating:
potatoes for dumplings, potato pancakes; fruit
and vegetables for raw vegetable salad.
Always observe the maximum quantities and
processing times in the table (Fig.=
Robert Bosch Hausgeräte GmbH
Exercise particular caution when handling
the attachments! Note shape and location
of the insert when inserting it into the carrier
disc. Take hold of carrier disc by the
designated recessed grips only.
.
-3)

Do not place fingers in the feed tube.
Only use the pusher when adding more
ingredients.
Caution!
The disc inserts must not be used for cutting
very hard foods (Parmesan cheese,
chocolate).
The disc inserts are only partly suitable
for processing fibrous foods (leek, celery,
rhubarb).
Fig.










Warning!
Empty the bowl before it becomes so full that
the cutting or grating contents reach the carrier
).

disc.

The blade is sharp and
can cause injury!

Place bowl on a smooth and clean work
surface.
Insert the required insert into the carrier
disc. Note the form and the location
(Fig. -1)!

Take hold of carrier disc by the recessed
grips and insert into the bowl.
Place lid on the bowl and turn all the way
anti-clockwise.
Place the base unit on the attachment and
lock into position.
Insert the mains plug.
Set the required speed with the speed
control.
Hold base unit and multifunction accessory
firmly and switch appliance on.
Put ingredients to be cut or shredded
through the feed tube.
When adding contents which are to
be sliced or shredded, apply only light
pressure to the pusher.
Release the On button after processing.
en
11