Functions - Oehlbach FALCON OB-6069 Mode D'emploi

Thank you
for choosing an Oehlbach® quality product. Please read these instructions carefully;
this will ensure the full and error-free functioning of the product.

Functions

· Wireless transmission of HDMI signals in FullHD and 3D
· Range up to 30m
· Transmission of IR signals from the remote control
· Very low latency of less than 0.5s
· HDCP-compliant
· Variety of setup options and flexible use
· Low power consumption
Specification
Supported sampling rates:
Range:
Frequency range:
Latency:
Audio formats:
Temperature range:
Permissible relative humidity: 5 to 90%
Power supply:
Power adaptor:
Dimensions (w x h x d):
Installation
1. Connect the „HDMI IN" connector of the Falcon HD transmitter to a source device (DVD, BluRay player,
PC). You can do this using the HDBI cable provided. You can use the „HDMI OUT" output on the trans-
mitter at the same time to transmit the HDMI signal to another device.
2. Connect the „HDMI OUT" connector of the Falcon HD receiver to an output device (TV, monitor, projec-
tor). You can do this using the HDBI cable provided.
3. Connect the IR emitter (2.5mm jack plug) to the IR OUT socket on the Falcon HD transmitter. Position
the IR emitter in such a way that is it pointing towards the IR sensor of the source device.
4. Connect the IR receiver (3.5mm jack plug) to the IR IN socket of the Falcon HD receiver. Position the
IR receiver in such a way that you can reach this with the IR signal from your source device remote
control.
5. Connect the Falcon HD transmitter to the power adaptor provided.
6. Connect the Falcon HD receiver to the power adaptor provided.
8
1080p/1080i/720p/576p/576i/480p/480i
up to 30 m
WiFi - 5GHz band
< 0.5 secs
Dolby TrueHD/DTS-HD-Master Audio/LPCM/Dolby AC3/DTS-7.1/DSD
0 to +50 °C
5V DC / 1A
100 - 230V / 50 – 60 Hz
85 x 27 x 85 mm