Nicols Moove led Manuel D'utilisation page 11

effectiveness is impaired.
● The lamp (LED) shall be changed if it has become damaged or thermally deformed.
PART 2 INSTALLATION
2.1 Mounting:
2.1-1 Hanging
The product can be mounted in a hanging position using the supporting bracket. The bracket should be secured to the
mounting truss or structure using a standard mounting clamp. Please note that when hanging the unit a safety cable
should also be used
.
2.1-2 Upright
The product can be mounted in an upright or sitting position using the supporting brackets.
NOTE:
The product can be mounted at any angle and in any position. It is possible to further adjust the angle of the product using
the two adjustment knobs located on the side of the fixture.
2.2 Special construction for DMX connection.
☆ At last fixture, the DMX cable has to be terminated with a terminator to reduce signal errors. Solder a 120-ohm 1/4W
resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
☆ If the controller is 5-pin output, it's necessary to use an adaptor to transfer signal from 5-pin output to 3-pin XLR-plug or
you can connect cables as following:
PART 3 Display Panel Operation
3.1 Disp la y panel menu instruction
[MENU] menu selection or return to previous menu.
[UP] press [UP] through the menu list to increase/change the value of the current function.
[DOWN] press [DOWN] through the menu list to decrease/change the value of the current function.
[ENTER] confirm & quit out current function setting.
3.2 Display panel operation instruction
Menu Item 1
Choose Pattern Static
Item 2 Item 3
Color (Dimming)
10