Edirol UA-1X Mode D'emploi page 15

■ Windows Me Users
1
With the UA-1X disconnected from your computer,
turn on your computer and start up Windows.
Disconnect all USB cables except for a USB keyboard and
USB mouse (if used).
2
Use a USB cable to connect the UA-1X to your
computer.
fig.02-03.e
3
Windows will detect the
UA-1X, and the "Add New
Hardware Wizard" dialog box
will appear.
Make sure that Automatic search
for a better driver (Recommended) is selected, and
click [Next]
4
The search for the driver starts.
5
When the correct driver is found, driver installation
starts.
fig.02-04.e
6
When a dialog box informing
you that driver installation
has finished appears, click
[Finish], and restart
Windows.
Next, you need to make the driver settings.
→ Settings and Checking (p. 19)
.
Connections and Driver Installation (Windows)
This unit is equipped with
a protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
Some time may be required
until this dialog box appears.
Depending on your computing
setup, there may be a short
wait after the driver is
installed until the device
is recognized.
15