Safety Precaution; Installation Instructions - Gorenje DKG6330E Notice D'utilisation

GENERAL
Carefully read the following important information regard-
ing installation safety and maintenance. Keep this infor-
mation booklet accessible for further consultations.
The appliance has been designed for use in the ducting
version (air exhaust to the outside – Fig.1B), filtering version
(air circulation on the inside – Fig.1A) or with external motor
(Fig.1C).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating simultane-
ously with an open fireplace or burner that depend on the
air in the environment and are supplied by other than
electrical energy, as the cooker hood removes the air from
the environment which a burner or fireplace need for
combustion. The negative pressure in the environment must
not exceed 4Pa (4x10-5 bar). Provide adequate ventilation
in the environment for a safe operation of the cooker hood.
Follow the local laws applicable for external air evacua-
tion.
Before connecting the model to the electricity network:
- control the data plate (positioned inside the appliance) to
ascertain that the voltage and power correspond to the
network and the socket is suitable. If in doubt ask a qualified
electrician.
- If the power supply cable is damaged, it must be replaced
with another cable or a special assembly, which may be
obtained direct from the manufacturer or from the Technical
Assistance Centre.
2. WARNING !
In certain circumstances electrical appliances may be
a danger hazard.
A) Do not check the status of the filters while the
cooker hood is operating
B) Do not touch bulbs or adjacent areas, during or
straight after prolonged use of the lighting installation.
C) Flambè cooking is prohibited underneath the
cooker hood
D) Avoid free flame, as it is damaging for the filters
and a fire hazard
E) Constantly check food frying to avoid that the over-
heated oil may become a fire hazard
F) Disconnect the electrical plug prior to any mainte-
nance.
G) This appliance is not intended for use by young
children or infirm persons without supervision
H) Young children should be supervised to ensure
they do not play with the appliance
I) There shall be adequate ventilation of the room
when the rangehood is used at the same time as ap-
pliances burning gas or other fuels
L) There is a risk of fire if cleaning is not carried out
in accordance with the instructions
This appliance conforms to the European Directive EC/
2002/96, Waste Electrical and Electronic Equipment
(WEEE). By making sure that this appliance is disposed of
in a suitable manner, the user is helping to prevent potential
ENGLISH
damage to the environment or to public health.
The symbol on the product or on the accompanying
paperwork indicates that the appliance should not be
treated as domestic waste, but should be delivered to a
suitable electric and electronic appliance recycling
collection point. Follow local guidelines when disposing of
waste. For more information on the treatment, re-use and
recycling of this product, please contact your local authority,
domestic waste collection service or the shop where the
appliance was purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried
out by specialised personnel.
• Electrical Connection
WARNING:
This is a class I, appliance and must therefore be
connected to an effiecient earthing system.
The appliance must be connected to the electricity supply
as follows:
BROWN = L live wire
BLUE = N neutral
YELLOW / GREEN =
The neutral wire must be connected to the terminal with
the N symbol while the YELLOW / GREEN, wire must be
connected to the terminal by the earth symbol
WARNING:
When connecting the appliance to the electricity supply,
make sure that the mains socket has an earth connection.
After fitting the ducted cooker hood, make sure that the
electrical plug is in a position where it can be accessed
easily.
If the appliance is connected directly to the electricity
supply, an omnipolar switch with a minimum contact
opening of 3 mm must be placed in between the two; its
size must be suitable for the load required and it must
comply with current legislation.
• The minimum distance between the support surfaces of
the cooking pots on the cooker top and the lowest part of
the cooker hood must be at least 65 cm. If a connection
tube composed of two parts is used, the upper part must
be placed outside the lower part. Do not connect the cooker
hood exhaust to the same conductor used to circulate hot
air or for evacuating fumes from other appliances gener-
ated by other than an electrical source.
Before proceeding with the assembly operations, remove
the anti-grease filter(s) (Fig.8) so that the unit is easier to
handle.In the case of assembly of the appliance in the
suction version prepare the hole for evacuation of the air.
• We recommend the use of an air exhaust pipe with a
diameter of 150. If a pipe with a smaller diameter is used,
the efficiency of the product may be reduced and its
operation may become noisier
• Replacing halogen light bulbs (Fig. 7).
To replace the halogen light bulbs B, remove the glass
- 18 -
GB
earth
.