Madison MAD-LINK Manuel D'utilisation page 2

Safety instructions
Read, follow and keep these Instructions for future reference.
l
Do not use this apparatus near water.
l
Clean only with a damp cloth.
l
Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions.
l
Do not install near nay heat sources such as radiators, heat registers, stoves, or other apparatus (including
l
amplifiers) that produce heat.
Protect the power cord from being walked on or pinched particularly at plug, convenience receptacles, and
l
point where they exit from the apparatus.
Unplug this apparatus during lighting storms or when unused for long periods of time.
l
Refer all servicing to qualified service personnel. Serving is required when the apparatus has been damaged
l
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped.
This mains plug is used as the disconnect device, the disconnect device shall be readily operable.
l
Description
F1/F2: quick play button. Long press F1 for factory reset.
Long press F2 for MCU upgrade
Power button
WPS: set up a new connection/play or pause
VOL+: turn up volume (long press or short press)
VOL-: turn down volume (long press or short press)
1. AUX input
2. 24Vdc 2A input
3. LAN connector
4. USB input
Operation
Insert the 24V/2A power adapter into the WIFI
speaker's power connector.
Short press the On/Off button to power on the unit. After a few seconds you will
hear a WIFI prompt tone. Now you can set up the connection.
If your WIFI speaker has already been connected to you router before, it will
appear on the device list.
Connection setup
If you want to set up a new WIFI speaker to your network, press "Add Device" on
the start page or press the cross icon on the top right corner of the device list and
turn to the WIFI setup interface. Press the WPS key on the WIFI speaker until you
hear a voice prompt "WIFI searching". Press "Next" on the APP and enter router password. Wait for a few
minutes and your WIFI Speaker will be added to the same network.
GB