Record Schedule - Dedicated Micros Eco4 Guide D'installation

Record Schedule

Standard PPS
Day 3
Night 3
Weekend 3
Recorded file size 18 KB
Max recording time --:--
Main storage (protected%) 141GB
Earliest recording 01/06/2003
Note: The Night and Weekend options are only displayed if a corresponding
Night and Weekend schedule has been configured in the Schedule menu page.
Standard and Event PPS
Select a record rate in pictures per second (PPS) to be recorded across all cameras.
When a single camera is being recorded. The maximum record rate is 25PPS for
PAL and 30PPS for NTSC cameras when a single camera is recorded.
The default record rate is 3PPS, this is the equivalent to a VCR in 48-hour time-
lapse mode. However, because there are only a maximum of 4 cameras the
update rate is faster than a 24-hour time-lapse mode recording 9 or 14 cameras.
12
Event PPS Events active
3 Both
Alarms
Activity
None
3 Both
Alarms
Activity
None
3 Both
Alarms
Activity
None
0%
12:00
To configure Eco4 to record only events, select the Standard PPS as 0PPS and the
Event PPS to a value you want the events to record at for example, 3PPS. The
Eco4 will then not record any cameras until activity or alarms are triggered, it will
then record the alarmed/activity camera interleaved with the other cameras.
The table below shows the equivalent record rates of typical VCR time-lapse modes:
VCR Time-lapse mode (hours)
3 (2)
12
24
48
72
168
Figures in brackets are for NTSC systems.
Tip: To work out the update rate per camera - the number of seconds before the
camera is updated. Divide the number of cameras by the record rate (PPS). For
example, 4 cameras with a record rate of 3PPS will be:
Update rate (seconds) = Number of cameras = 4 = 0.67 seconds
PPS
You can decrease the update rate by increasing the record rate (PPS), the only
drawback is that the recording time will also decrease.
Events active
Select whether the alarms and activity are on or off for day, night, and weekend
schedules.
Eco4 Record rate (PPS)
25 (30)
12
6
3
2
1
3