English
workpiece; remove them before you
start working.
• Use suitable detectors to find hidden
utility lines or call the local utility com-
pany for assistance (contact with elec-
tric lines can lead to fire or electrical
shock; damaging a gas line can result in
an explosion; penetrating a water pipe
will cause property damage or an elec-
trical shock).
• Secure the workpiece (a workpiece
clamped with clamping devices or in a
vice is held more securely than by
hand).
8. During use
• Hold power tool by insulated gripping
surfaces (7), when performing an oper-
ation where the cutting accessory or
fastener may contact hidden wiring
(cutting accessory and fasteners con-
tacting a "live" wire may make exposed
metal parts of the power tool "live" and
could give the operator an electric
shock).
• In case of electrical or mechanical mal-
function, immediately switch off the
tool or unplug charger from power
source.
9. Before first use
Remove the machine and the accessories
from the packaging. Check the machine for
transport damage and do not use the
machine in case of damages. Keep the
packing materials away from children, risk
of suffocation!
10. Intended use
The cordless hammer drill/screwdriver is
designed for tightening and undoing screws,
Selection:
11.5
Screwing
Drilling Masonry /
Concrete
Drilling Wood
Drilling Metal
18
7063099-Cordless_Impact_Drill-18V-Ma-1903-19.indb 18
Mode selector
Torque selector
1 – 20 *
N/A
N/A
N/A
for drilling in wood, metal and plastic, and
for hammer drilling in stone, in each case
when using the appropriate bits. The equip-
ment is to be used only for its prescribed
purpose.
11. Operation of machine
Direction control
11.1
• The direction of rotation can be set
using the Forward/Reverse Switch (6).
• For anti-clockwise rotation, push the
switch to the right.
• For clockwise rotation, push the switch
to the left.
Note: When the Forward/Reverse Switch is
in the central position, the drill is locked and
cannot be switched on. Use this setting as a
safety feature to prevent the drill from being
switched on accidentally.
Mode selector
11.2
The clutch settings are indicated by the
symbols on the Mode Selector (3).
Torque Selector
11.3
Rotate the Torque Selector (3) to select the
desired setting: the higher the number dis-
played on the torque ring, the higher the
torque produced by the tool.
Speed setting
11.4
The machine has 2 drill speeds, which can
be adjusted by sliding the gear switch (4)
forward or backwards. The number on the
gear switch (4) shows which position is
chosen.
Position 1: For slow drilling, large drilling
diameter or screw driving. The machine has
higher torque at a low speed.
Position 2: For fast drilling or small drilling
diameter. The machine has lower torque at
a high speed.
Speed
1
2
1 or 2
1 or 2
28/03/2019 11:05