Assemble Drawer - Gladiator GAGB28KDYG Instructions D'assemblage

4a.

Assemble Drawer

F3c Phillips-head screw (22)
D1
IMPORTANT: Position the drawer sides so that the glides are at
the top and facing the outside. Do not fully tighten the six screws
attaching the drawer back to the sides. Using three Phillips-head
screws (F3c), attach the side (D1) to the back (D2) as shown.
NOTE: Working from the back, insert the screws through the
drawer back and then into the drawer side. Using three Phillips-
head screws (F3c), attach side (D3) to the back (D2) as shown.
NOTE: Working from the back, insert the screws through the
drawer back and then into the drawer side. Working from the top,
set the drawer bottom (D4) down onto the back and side flanges
as shown. Working from the bottom, insert screws through the
drawer back and sides and then into the drawer bottom.
NOTE: Wait until the drawer front is in place before inserting the
screws that attach the drawer bottom to the front.
4c.
Assemble Drawer
D2
P3
P6
A. Tighten drawer screws
Once the drawer is in place, work from the rear of the cabinet to
completely tighten the six screws attaching the drawer back.
6
F3c
D4
D2
D3
A
P2
P1
4b.
Assemble Drawer
D3
D2
A. Drawer glide lever
Using nine Phillips-head screws (F3c), attach the drawer front (D5)
to the bottom and sides. Before you insert the drawer into the
cabinet, make sure the bearing carriages on the cabinet slides are
at the front of the cabinet. Align the drawer glides with the slides
on the inside of the cabinet. Insert the drawer glides into the
slides and push the drawer into the cabinet.
NOTE: If the drawer glide is not correctly aligned with the cabinet
slide, the drawer may become lodged in the cabinet. Facing the
cabinet, press down on the lever located on the right-hand drawer
glide while pressing up on the lever located on the lefthand
drawer glide to release the drawer.
D5
D4
D1
A