Kraft Werkzeuge 3903805917 Traduction De La Notice Originale page 23

Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point.
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper han-
dling of waste equipment may have negative conse-
quences for the environment and human health due
to potentially hazardous substances that are often
contained in electrical and electronic equipment. By
properly disposing of this product, you
are also contributing to the effective use of natu-
ral resources. You can obtain information on collec-
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
13. Troubleshooting
Fault Possible cause
1. Power tool does Power supply interrupted
not start
Power cord or plug defective
Other electrical defect of the power tool
2. Power tool Extension cord too long and/or cross-section
does not oper- too small
ate with full
Power supply (e.g. generator) voltage too low
power
3. Poor operation Sanding paper worn out
results
Abrasive plate worn out
4. Considerable Brush edge (around the sanding disc) worn out Replace brush edge by specialist
dust formation
Dust extraction not connected / switched on
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Carbon brushes, Grinding plates, Brush
head, Sanding paper
* Not necessarily included in the scope of delivery!
Remedy
Check power supply by connecting another
power tool
Electrician must check the tool
Electrician must check the tool
Use extension cord with permissible length and/
or adequate cross-section
Connect power tool to an appropriate power sup-
ply
Replace sanding paper
Replace abrasive plate by specialist
Connect / switch on dust extraction
23 І 36