Wolf 10E Instructions D'utilisation page 6

Safety instructions
Contents
1 Collector return branch with solar
circuit pump, flow regulator and
temperature display
2 Front insulating shell
3 Rear left insulating shell
4 Rear right insulating shell
5 Wall mounting brackets
Technical data
6
Operation instructions for contractors
GB
Solar pump assembly 10E / 20E
The following symbols and signs are used in this description. These important instructions
concern personal safety and technical reliability.
"Safety instructions" identify instructions with which you must exactly comply to prevent
injury and damage to the equipment.
Danger through 'live' electrical components.
Warning: Switch the ON/OFF switch to OFF before removing the casing.
Never touch electrical components or contacts when the ON/OFF switch is in the ON posi-
tion. This brings a risk of electrocution, which may result in injury or death.
The supply terminals are still "live" even when the ON/OFF switch is OFF.
"Information" identifies technical instructions which you must observe to prevent damage
Warning
and avoid malfunctions.
Installation, commissioning, inspection, service and maintenance must be
carried out by a recognised specialist. The standards and directives applicable
to the respective country must be observed.
Flow regulation
Max. allowable operating overpressure
Max. system temperature
(at 50 °C ambient temperature)
Short-term temp. resistance up to
Pump-specific data and performance curves are contained in the separate pump
manual supplied.
Solar pump Solar pump
assembly 10 E assembly 20 E
2 - 15 l/min 7 - 30 l/min
10 bar
110 °C 110 °C
140 °C 140 °C
3062506_201911
10 bar