Alto Professional Truesonic TS115W Guide D'utilisation Rapide page 20

SPECIFICATIONS
Output Power:
Crossover:
Max SPL @ 1m:
Frequency Response:
Frequency Range:
Low Frequency:
High Frequency:
Horn Coverage:
Input Control:
External Control:
Connectors:
Wireless connectivity:
Wireless range:
Protection features:
Power supply:
Cabinet:
Mounting information:
Dimensions (H x W x D):
Weight (speaker only):
FCC ID: Y4O-TS115W
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
SHIELDED CABLES MUST BE USED WITH THIS UNIT TO ENSURE COMPLIANCE WITH THE CLASS B FCC LIMITS.
Inrush current at initial switch-on: 6.01 A
Inrush current after power supply interruption: 4.44 A
www.altoprofessional.com/wireless
800 W Peak (670 W LF + 130 W HF)
400 W Continuous RMS (335 W LF + 65 W HF)
2.5 kHz
125 dB Peak, 122 dB Continuous
65 Hz – 19 kHz (+ 3 dB)
54 Hz – 20 kHz (@ -10 dB)
15" (381 mm) woofer, 2" (51 mm) voice coil
Neodymium compression driver, 1" (25 mm) exit, 1" (25 mm) voice coil
80/100° H x 60° V, nominal (@ -6 dB)
Line/Mic –∞ to +50 dB
Max input level: +23 dBu
Impedance: 15 kΩ
Volume, power on/off with LED, clip limiter with LED, ground lift
Input: Two 1/4" TRS or XLR
Link: One XLR
Bluetooth (A2DP)
60-80 feet (18-24 meters), typical
Over-excursion, thermal, driver
100 VAC, 110-120 VAC, or 220-240 VAC; 50/60 Hz
Trapezoidal with floor monitor capability. Injection-molded polypropylene
with perforated steel grille
Integrated pole socket (36 mm diameter); 2 handles; 6 M10 threaded
sockets (2 top, 2 bottom, 2 pullbacks)
26.75" x 16.9" x 14.3" (679 mm x 430.3 mm x 365 mm)
39.6 lbs. (18 kg)
Bluetooth PIN #: 0000
MANUAL VERSION 1.4