Battipav LEGGERA 6401E Mode D'emploi page 12

GB
CAUTION
11
• Adjust the cutting wheel by tightening the
screw with a 3 mm male hexagonal wrench,
until the lateral backlash is reduced, avoiding
any locking.
ADJUSTMENT OF CUTTING CARRIAGE
• Remove any residues from the slide bar of the
cutting carriage, without lubricating.
12 • Eliminate the lateral backlash of the carriage,
by acting on the screw indicated in picture 14,
using a 4 mm hexagonal head wrench.
CAUTION
AN EXCESSIVE ADJUSTMENT WILL DAMAGE THE
GOOD SLIDING OF THE CUTTING CARRIAGE.
CLEANING
Keep the slide bar clean using an all-purpose lubricant
DISPOSAL
In the event of scrapping the entire machine or part
of it, it must be disposed of in accordance with the
methods laid down by current legislation.
Worktable
Aluminium
Steel
Polyamide
Carriage rod
Steel
Aluminium
Polyamide
12
Carriage
AL
AC
PA
AC
AL
PA
Battipav srl