Electromagnetic Fields (Emf); Before First Use; Flushing The Appliance - Philips D7751/00 Mode D'emploi

• if a problem occurs that you cannot solve
by means of this user manual, contact the
Consumer Care Centre in your country. if the
problem cannot be solved, take the appliance
to a service centre authorised by Philips for
examination or repair. Do not attempt to
repair the appliance yourself, otherwise your
guarantee becomes invalid.
3.3 Caution
•
Do not place the appliance on a hot surface
and prevent the mains cord from coming into
contact with hot surfaces.
•
Unplug the appliance if problems occur during
grinding or brewing and before you clean it.
•
The jug is hot during and after brewing.
Always hold the jug by its handle.
•
Never use the jug in a microwave oven.
•
Do not move the appliance while it is
operating.
•
Wait until the appliance has cooled down
before you store it. The hotplate and the
coffee jug may be hot.
•
After you have unpacked the appliance, make
sure it is complete and undamaged. if in doubt,
do not use the appliance but contact the
Consumer Care Centre in your country.
•
This appliance is intended for normal
household use only. it is not intended for
use in environments such as staff kitchens
of shops, offices, farms or other work
environments. Nor is it intended to be used
by clients in hotels, motels, bed and breakfasts
and other residential environments.
3.4 Electromagnetic fields
(EMF)
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this
user manual, the appliance is safe to use based on
scientific evidence available today.
6
4 Before first use

4.1 Flushing the appliance

You need to flush the coffeemaker once before
first use.
Put the mains plug in the wall socket.
1
• The start/standby button lights up.
Press the start/standby button (Fig. 2).
2
• The display lights up and the appliance
beeps.
Note:
D
if you do not press any button within 5
minutes, the appliance goes into standby
mode. in this case, the display goes out and
only the start/standby button stays on to
indicate that the appliance is still switched on.
in standby mode, you can press any button to
reactivate the appliance.
Open the water reservoir lid. Fill the water
3
reservoir with fresh cold water up to the
10-cup indication (Fig. 3).
Note:
D
Do not put coffee beans or ground coffee in
the appliance.
Close the water reservoir lid.
4
Place the jug on the hotplate (Fig. 4).
5
Note:
D
Make sure the lid is on the jug and the jug is
properly placed on the hot plate. The spout of
the jug has to face forward into the appliance.
if the lid is not on the jug or the jug is not
properly placed, the drip stop function is
automatically activated (see chapter 'Using the
appliance', section 'Drip stop function').
Press the start/standby button (Fig. 5).
6
• The appliance beeps and the freshness
indicator appears on the display.
Press the pre-ground coffee button to switch
7
off the grinder (Fig. 6).
• The button lights up when you press it.