Removal Of Transit Screws; Use - R&S Vibracap Mode D'emploi

BEFORE USING REMOVE TRANSIT SCREW FROM UNDERSIDE OF UNIT. (Fig A)
For safety during transit, the amalgamator has been fitted with a transit screw prior to shipping. It is essential to remove this
screw prior to using the amalgamator:
a) Place the unit on its side on a soft surface.
b) Using the supplied 3mm allen key, turn the transit screw anti-clockwise until it is loosened. Remove screws.
c) Place the amalgamator correct side up on a flat surface in a easily accessible location.
Packaging part list: Electronic Control Console - Power Cord - Allen Key - Instruction manual
(Fig. B)
1.
Connect the power cord with the socket at the rear of the apparatus and subsequently with the mains socket. (Fig. C)
2.
Switch on the apparatus at the rear. (Fig. C)
3.
Raise the safety cover and place the mixing capsule in the mixing. (Fig. D)
- Insert the capsule in the right cap of plastic fork. (Fig. D-1)
- Open the fork moving the left part. (max 8 mm) (Fig. D-2)
- Turn the capsule inside the plastic fork. (Fig. D-3)
- Check the capsule is clamp correctly.

5. REMOVAL OF TRANSIT SCREWS

Fig. A

6. USE

Fig. B
i
11