Operation On Battery Power; Transfer To Battery Power; Return Of Ac Power; Ups Shutdown - MGE Pulsar M 2200 RT 2U Manuel D'installation Et D'utilisation

Pulsar M
3.2

Operation on Battery Power

Transfer to battery power

Low on battery power
End of battery backup time
◗
All the LEDs go OFF.
◗
The audio alarms stop.
i
The UPS is completely shut down
3.3

Return of AC power

Following an outage, the UPS restarts automatically when AC power returns (unless the restart function was disabled via
UPS personalization) and the load is again supplied.
3.4

UPS shutdown

3 — 2
◗ The connected devices continue to be
◗ LEDs (20) and (21) go ON.
◗ The audio alarm beeps every ten seconds.
◗ LEDs (20) and (21) go ON.
◗ The audio alarm beeps every three seconds.
Press button (27) for approximately 2 seconds.
The devices connected to the UPS are no longer
supplied.
Operation
E E N N G G L L I I S S H H
supplied by the UPS when AC power is no
longer available. The necessary energy is
provided by the battery.
The connected devices are supplied by the
battery. The display indicates the remaining
backup time.
The remaining battery power is low.
Shut down all applications on the connected
equipment because automatic UPS shutdown
is imminent.
86-86710-00 A01