Commissioning; Operation - Hengst Blue.Care+ Notice D'utilisation

6. Commissioning

Safety notices
Danger:
Do not operate machine without filter.
Warning:
GB
Danger of injury from falls after climbing on the machine. Climbing on the machine is
prohibited.
Note:
When moving the machine for use in a different location, cables must be properly routed.
First unplug the mains plug. Do not kink cables; damaged cables must be replaced.
Do not operate the machine in high-moisture areas.
Operating elements and display elements
The air purifier is operated by means of the mains cable, the On/Off switch and the volume flow cont-
roller.
On/Off switch
Power cable
34.
80
50
100
120
Volume flow controller
| Original operating manual | Article number 129-300-000 I Subject to alteration
Marking of next maintenance
You can use the maintenance sticker included with the machine to mark the next filter change – always
6 months from start of operation with a new filter.
Filter
Service

7. Operation

Set up the machine on a clean, level surface (for ambient conditions, refer to chapter "Technical data").
Filter
The ambient air should not contain excessive dust.
Service
The air supply slots and exhaust outlets on the housing must be kept free and must always be at least
30 cm from walls.
Set castor brake and ensure that the machine is stable.
Plug in the mains cable and route the cable so there is no danger of tripping.
Switch the machine on and off with the "On/Off" switch. The On/Off switch is illuminated during opera-
tion. Operation is permissible only with the correct filter installed.
95 x 95mm
The machine can be adjusted for the size of the room by means of the volume flow controller.
| Original operating manual | Article number 129-300-000 I Subject to alteration
Filter
Service
Filter
Service
GB
35.