Venmar C180 Série Directives D'installation, D'utilisation Et D'entretien page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11. OPERATION (
R
E
OUND
LECTRONIC
HC0023
A
A. D
S
:
ELAY
WITCH
When a blower speed is selected, press this switch to activate the delay function. The
corresponding blower speed switch will flash to indicate this function is activated. The blower
will continue to operate for 5 minutes and will stop automatically. To cancel the delay function,
press the delay switch once again.
B. S
/S
/S
TART
TOP
PEED
Press the switch corresponding to the desired blower speed (from 1 for low speed to 4 for high
speed). The chosen switch will light. To turn off the blower, press once more on the
corresponding blower speed switch; the switch light will shut off.
NOTE: When blower is off, pressing on blower speed 1 switch will cause the blower to start on
high speed for a very short lapse of time, and then resume on speed 1.
C. M
OFF/F
ASTER
ILTER
i. To turn off the blower and the light simultaneously, press this switch once.
ii. After 25 hours of operation, this switch will light to indicate the filters and the blower wheel(s)
need to be cleaned in order to maintain efficient operation of the unit. The switch light will
stay on until the function is reset by pressing this switch for 3 seconds.
iii. The light indicator is used for the Heat Sentry function as well (
).
MODELS
H
S
™: The hood is equipped with a protective device that activates when excessive
EAT
ENTRY
D. L
S
:
IGHT
WITCH
This switch allows three different lighting levels according to your needs. Press once for
nightlight, twice for normal or three times to obtain full intensity. To shut off the lights without
turning off the blower, press once more.
'
)
CONT
D
C
ONTROL
S
S
ELECTION
WITCHES
M
/H
AINTENANCE
heat is detected inside the hood and when it is set on speed 4. This device
takes control of the blower and deactivates speed 4 for a 10-minute period and
sets it on speed 3. During the Heat Sentry activation, only speed 3 can be
used; the Heat Sentry button (C) will flash while the speed 3 button will light.
The hood can also be turned OFF.
B
:
S
(T
EAT
ENTRY
RIPLE
- 14 -
C
F
S
):
UNCTION
WITCH
NOT AVAILABLE ON ALL HOOD
D

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières