Declaration Of Compliance; Range Technical Data Table; Instructions For Installation; Installation - Lotus cookers CF4-78ET Instructions Pour L'installation Et L'emploi

Cuisinières avec four électrique usage professionnel

Masquer les pouces

Table des Matières

Les langues disponibles

The manufacturer declares that the appliances are compliant with the prescriptions of the EEC norm 2009/142 for the

gas part and with norm

2006/95/CE,

in force particularly concerning room ventilation and discharging gas emissions.

N.B.: The manufacturer declines any responsibility for direct or indirect damage caused by improper or incorrect

installation, alterations, maintenance or use of the appliance, as in all the other cases considered in the items of our sales

conditions.

DIMENSIONS

MODELS

CF4-78ET

80x70x90

CFQ4-78ET

80x70x90

CFC4-78ET

80x70x90

CF6-712ETV

120x70x90

CFQ6-712ETV

CF6-712ET

120x70x90

CFQ6-712ET

CFV4-78ET

80x70x90

CFVQ4-78ET

80x70x90

CFVC4-78ET

80x70x90

CFV6-712ETV

120x70x90

CFVQ6-712ETV

The data plate is on the front (see diagram in electric connection item) and has all the data necessary for the connection.

When fitting, the appliance must be levelled using a spirit level; slight differences of level can be adjusted by screwing

or unscrewing the adjustable feet. The main switch or the socket must be near the appliance and easily accessible.

It is advisable to place the appliance under an extractor hood so that steam is extracted rapidly. If the appliance is placed

near walls, dividing panels, kitchen furniture, decorative finishing, etc. , these should be in flameproof material;

otherwise it is necessary to cover them with non-flammable material.

Above all, it is necessary to ensure that the fire prevention norms are observed.

The installation, starting up and maintenance of the appliance must be carried out by qualified personnel. All operations

done when installing must be carried out observing the norms in force.

The manufacturer declines all responsibility in the event of incorrect functioning due to wrong installation or

installation which does not comply with the norms.

Attention! In accordance with international rules, when connecting the appliance, an automatic device enabling the

disconnection of all contacts from the mains, must be installed above it; this device must have a contacts opening of at

least 3 mm.

Installation must be carried out observing the following norms:

- Safety prescription in force

- Installation prescription, norms in force.

The appliance is supplied without the connection cable. To install the power supply cable, proceed as follows:

•

Disconnect the power supply.

•

Remove the bottom panel

•

Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in

the junction box and fix them into place.