Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Step 5: Installing the Anti-Tip safety bracket
1. Attach Part G: Anti-Tip bracket (1 of 2)
Part H: Anti-Tip bracket (2 of 2) around Part
B: middle support frame as shown by joining
the two parts using Part N: Phillips head metal
screw and Part K: nut.
2. Align the assembled stacking kit in place against
the wall and mark where the Anti-Tip safety
bracket needs to be secured to the wall.
3. Use Part L: wall anchors and Part M: Phillips
head self-tapping screw to secure the
assembled stacking kit to the wall.
Important note: Ensure that
screws align with a wall stud to
ensure stacking kit stability.
Step 6: Installing the dryer
1. Remove the four levelling legs from the dryer.
2. Place the dryer on the top shelf of the
stacking kit.
3. Re-install the four levelling legs through the
underside of the top shelf and tighten until
dryer is secured in place.
Important note: If the dryer seems
unstable or if there is signifi cant
motion or noise from the dryer when
it is in use, ensure that the levelling
legs are tightened to minimize
vibration and noise.
and
6
Publicité
Table des Matières
