Perel WC222 Mode D'emploi page 5

5. Installation
Powering the Weather Station
The weather station requires one CR2032 battery as back-up
power in case of power interruption. Open the battery
compartment of the weather station. Insert the battery observing
the correct polarity and re-insert the battery door. Make sure to
remove the plastic strip before use.
Connect the weather station to the mains using the included
power adapter or an exact equivalent.
Installing the Outdoor Transmitter
Open the battery compartment of the transmitter and make sure
the channel selector is set at position 1. Insert two AAA batteries
observing the correct polarity and re-insert the battery door.
Hold the transmitter close to the weather station. The weather
station will receive data from the transmitter within a few
seconds.
Insert the holder to the bottom of the transmitter for desktop
use, or insert it to the back for wall-mount use.
Now, install the transmitter in a dry and shady spot, away from
direct sunlight or rain.
Temperature readings will become stable and more accurate
after around 30 minutes.
V. 01 – 05/12/2019
WC222
5 ©Velleman nv