Korg NC-Q1 Manuel D'utilisation page 12

Making a call
Make the call from the smartphone or mobile phone.
Receiving a call
When you hear the ring tone from this
unit, press the function button on the
right side of the unit.
Ending a call
During the call, press the function button.
If a call is made during music playback, playback will pause. When the
call ends, playback resumes automatically.
HINT
Noise-cancelling function
You can comfortably enjoy music while reducing ambient noise.
Using noise cancelling
■
Press the NC button on the right side of the unit
to turn on/off noise cancelling.
• Turning on this unit turns on the NC indicator and
noise cancelling.
• Turning off noise cancelling goes off the NC
indicator.
• The NC indicator flashes when ambient sound
monitoring is on or after switching the ambient
sound monitoring.
12 NC-Q1 SMART NOISE CANCELLING DJ HEADPHONES
If this unit is turned on with no Bluetooth device or headphone cable
connected, only the noise-cancelling function can be used.
HINT
Noise cancelling in high-volume environments
■
In environments with extremely loud ambient sound, such as at live venues,
interruption or malfunction of noise cancelling can be reduced by turning on
the attenuator of this unit.
• When noise cancelling is on, press the ATT
button on the right side of the unit to turn on the
attenuator.
Ambient sound monitoring function
Using the built-in microphone, you can listen to the ambient sound.
Change the settings to adjust the monitoring volume and EQ of the ambient sound.
Turning on/off ambient sound monitoring
■
Touch the touch sensor on the right side of the unit to
turn on ambient sound monitoring.
• Operate the touch sensor by covering it with the palm of your
NC indicator
hand as illustrated.
• The ambient sound monitoring can be switched to either
NC button
the left or right microphone, or both the left and right
microphones.
• It takes about 10 seconds after turning on the
unit, and about 3 seconds after wearing the
NOTE
unit, before you can use the touch sensor.
• If the touch sensor does not respond, adjust
the length of the headband so that the
earpads fit snugly on your head.
ATT
Touch sensor