Bestron AST9000 Mode D'emploi page 24

use -
dry ironing
1. Insert the plug (13) into the wall socket.
2. Turn on the main on/off switch (11) by switching it to position 1.
The pilot light turns on.
3. Turn the iron temperature control dial (2) to the desired position (see the table in 'Ironing instructions').
The pilot light (9) turns on.
4. Place the iron in a vertical position (upright) and wait until the pilot light (9) goes out. The iron is now
ready to iron.
Iron the fabric by sliding the iron over the fabric. While you are ironing, the heating element will
automatically switch on and off to keep the soleplate at the set temperature. The pilot light (9) will,
therefore, also turn on and off automatically.
5. After use, rotate the iron temperature control to the 0 position, turn off the main on/ off switch by
switching it to position 0. Remove the plug from the wall socket. Place the iron in a vertical position and
allow it to cool down.
use -
steam ironing
1. Fill the water tank (see 'Filling the water reservoir').
2. Insert the plug (13) into the wall socket.
3. Turn on the main on/off switch (11) by switching it to position 1.
The pilot light turns on.
4. Turn the boiler temperature control (12) to MAX.
The pilot light (10) turns on.
5. Turn the iron temperature control dial (2) to the desired position (see the table in 'Ironing instructions').
The pilot light (9) turns on. The iron will be ready for use when the pilot light goes out and the
temperature is reached.
6. When both pilot light go out, you can start steam ironing.
When the steam pilot light (10) lits, you must wait until the boiler has built up sufficient steam
pressure again.
The steam spray of this product can only be smooth after pressing the steam iron button for several
times.
Leave the device steaming (for ca. 20 sec) before every use by pushing the steam release button (3)
to remove calcium deposits.
7. After use, rotate the iron temperature control to the 0 position, turn off the main on/ off switch by
switching it to position 0. Remove the plug from the wall socket. Place the iron in a vertical position and
allow it to cool down.
If the temperature is too low, drops of water can escape with the steam. This can cause stains. If this
does happen, you should turn the temperaturecontrol dial to the recommended position. Never iron
whilst there are drops of water on the soleplate.
use - Vertical s
team ironing
You can also release steam when the iron is held vertically, for example, to clean fabric. The best result is
achieved by ironing in two stages: moisten the article of clothing with steam first by holding the soleplate
approximately 20 cm above the clothing. Use more steam if the item of clothing contains a lot of creases.
Next, iron the item of clothing dry.
use -
ironing instructions
• Before ironing a garment check whether the garment has a label with ironing directions. Always follow
the instructions on the label. The following table explains the meaning of symbols that may be shown
on the label.
• You can also use the following table when the garment does not have a label but you do know which
fabric was used to make the garment.
24
user's instructions