Safety Precautions - Kenwood KSC-32S Mode D'emploi

saFeTY PrecauTIons

Please read all safety instructions before using this charger. For best results, be
aware of all warnings on the charger, the battery pack, and the product using the
battery pack. Follow the provided operating instructions, and retain them for future
reference.
• Do not disassemble the charger. Incorrect reassembly can cause fire or electric
shock.
Use of an attachment not recommended by nor sold by KENWOOD can cause
•
fire, electric shock, or injury.
• Do not expose the charger to rain or moisture, to avoid the risk of fire or electric
shock.
• Do not use an extension cable unless absolutely necessary. Improper extension
cables can cause fire or electric shock. If an extension cable is required, observe
the following points:
a) The quantity, size, and shape of pins on the extension cable plugs must be
the same as on the AC adapter supplied with the charger.
b) The extension cable must be properly wired and in good electrical condition.
c) The wire size must be adequate to carry the current required by this charger.
Extension cables shorter than 30 m:
• Wire size must be 18 AWG or larger.
Extension cables 30 to 45 m, inclusive:
• Wire size must be 16 AWG or larger.
• Always remove the AC adapter from a wall outlet before attempting to inspect or
clean the charger. Removing the battery packs or changing the controls does not
remove the AC voltage from the charger.
• Position the AC adapter cable so it will not be stepped on, tripped over, nor
subjected to damage.
• Always remove the AC adapter from an AC wall outlet by pulling on the adapter
rather than the cable.
• Do not use the charger if it has a damaged AC adapter or adapter cable, or if
the charger has been damaged in any way. Contact your KENWOOD dealer to
replace or repair the damaged part.
• Prevent strong impacts, such as caused by dropping, since the charger can be
damaged.
• Do not use the charger in hot or humid environments, in direct sunlight, nor near
heaters.
• Do not use solvents such as benzene or paint thinner to clean the charger.
• Use only the supplied AC adapter.
• The socket-outlet shall be near the equipment and shall be easily accessible.
• Do not install this equipment in a confined space such as a book case or similar
unit.
• Attention should be drawn to the environmental aspects of battery disposal.
6