Alto Professional LIVE 25 Guide D'utilisation Rapide page 6

CHANGING TO ANOTHER MIDI CHANNEL:
Sends a MIDI message to change to a certain MIDI Channel (default is Ch 1):
1. Hold the Shift button while pressing the keyboard's Channel key.
2. Use the keyboard's numeric keys to enter the MIDI Channel (1-16).
3. Press the keyboard's ENTER key to confirm your choice. The keyboard channel also affects the
MIDI channel of the joystick, pedals and slider.
SENDING A MIDI RESET MESSAGE:
There are two reset keys for resetting an external MIDI device by sending a MIDI reset message. Hold the
Shift button while pressing the [Reset all Controls] (sends CC#121) or [All Notes Off] (sends CC#123) key.
The SHIFT indicator will then turn off and the keyboard will go to normal play mode. Make sure your MIDI
device support the related MIDI reset message before using this function.
ASSIGNING THE JOYSTICK: This feature is for defining the downward joystick message.
1. Hold the Shift button while pressing the [Assign Joystick] key
2. Use the numeric keys to enter the controller value (0-127). The center position of the joystick will
send data 0, and the lowest position will send data 127.
3. Press the [Enter] button to send the data.
ASSIGNING THE SLIDER
1. Hold the Shift button while pressing [Assign Slider] key.
2. Use the numeric keys to enter the controller value (0-127) Value. The most left position of the
slider will send data 0, and the most right position will send data 127.
3. Press the [Enter] button to send the data.
ASSIGNING THE PEDAL PORT
1. Hold the Shift button while pressing [Assign Pedal] key.
2. Use the numeric keys to enter the controller value (0-127) Value.
3. Press the [Enter] button to send the data.
Note: Only a switch type pedal (momentary on/off footswitch) can be used for this function.
PEDAL POLARITY:
You can set the polarity of the switch type pedal. The default setting is "normally open".
To set this, hold the [Shift] button while pressing the【Pedal Polarity] key and the change will occur.
ASSIGNING OCT/TRANS BUTTON
You can assign the【- , +】buttons to default to Octave or Transpose. The default setting for the button is
Octave. To set this, hold the Shift button while pressing [Oct/Trans] key. You do not need to press Enter.
VELOCITY CURVE
There are 10 velocity curves that can be selected ranging from 0 – 9.
Operation：【SHIFT】 F2【Velocity Curve】 【Set value】and use the numeric key to select the curve
value. The default velocity curve number is 1.
GM/GS SWITCH
With the default setting, when you first use this feature, the GS (General Synthesis) On message will be sent.
When you trigger this feature again, the GM (General MIDI) On message will be sent out. Hold the [Shift]
button and press the [GM/GS] button to use this.
RECALL SETTINGS:
The LIVE keyboard's settings are non-volatile- its settings will be stored even if you turn the keyboard off or
unplug it from its power source. You may save your settings in 10 preset banks numbered 0 – 9. You can
recall one of them any time. The contents of the preset memory include: Oct/Trans setting, velocity curve, all
assignments for slider, pedal etc.
Recall Operation: Hold【SHIFT】press【Preset】 set value and simply press a number key.
Store Operation: Hold【SHIFT】press【Preset】+ set value simultaniously to select a register bank to store.
6