Télécharger Imprimer la page

Optional Equipment - NSS Outlaw PB Instructions D'origine

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles



Unbuckle the hip belt.



Carefully remove the Outlaw PB and place gently

on the floor or table for storage.

MAINTENANCE

Routine maintenance is critical to ensure proper

machine operation and cleaning performance. Perform

all maintenance procedures as follows:

Always disconnect and remove batteries before

performing any maintenance. See front page

for warnings.

Daily Maintenance

 Inspect the battery cord, battery connectors and

charger connectors for any damage.

 Remove the debris canister, remove the primary filter

and filter cup, and empty the contents into an approved

trash receptacle. See photos 18, 19 and 20.

Photo 18

Photo 19

Photo 20

Knock/shake the debris from the filter and cup into an

approved trash receptacle (photo 21). Always reinstall

the filter and the cup.

Weekly Maintenance

 Verify that all daily maintenance has been done.

 Inspect filters for wear, damage, or clogging. Clean

or replace as required. The primary pleated filter can

be rinsed out with water.

Every 6 months

 Charge all spare batteries within 6 months of date of

manufacture.

 Check carbon brushes for wear. When carbon

brushes are worn to 1/2" [12.7mm] in length return

the machine to an authorized NSS Service center.

 Inspect filter cup for clogging, or damage. Clean or

replace as needed. Can be cleaned with warm water

 Clean (with warm water running from inside out) or

replace the primary pleated filter as needed. Allow to

dry before use if cleaned with water.

 Inspect secondary foam filter for wear, clogging, or

damage. Clean or replace as needed.

 Inspect the HEPA filter (if equipped) for wear,

clogging, or damage. Clean or replace as needed.

Annually



Replace all filters.

Other



Replace batteries after approximately 500 cycles.

Batteries need replaced when runtime is

significantly diminished.