Tanaka TCS 27EPAP Mode D'emploi page 7

Cutting attachment to drive shaft
(Fig. 2)
Loosen tube locking bolt (3).
Insert the drive shaft into the gear case of the attachment
properly until the marked position (4) on the drive shaft
tube meets the gear case.
3
Installation of handle (Fig. 3)
Attach the handle to the drive shaft tube with the angle
towards the engine.
Adjust the location to the most comfortable position
before operation.
Throttle wire / stop cord
Press the upper tab (6) and open the air cleaner cover.
(Fig. 4)
Connect stop cords. (Fig. 5)
5
4
Fig. 2
Fig. 3
6
Fig. 4
Fig. 5
If the throttle outer end (7) is threaded on your unit,
screw it and the earth terminal (8) (if so equipped) into
the cable adjuster stay (9) all the way, and then tighten
this cable end using the adjuster nut (10) against the
cable adjuster stay (9).
Connect throttle wire end (11) to carburetor (12) and
install swivel cap (13) (if so equipped) where is included
in tool bag, onto swivel (12) (Fig. 6).
Some models may come with the parts installed.
8
7
WARNING
Never try to start engine without side case securely
fastened.
NOTE
When assembling brand new unit, take off and
discard a piece of cardboard (14) between gear case
and side case. (Fig. 7)
14
Installation of bar and chain
1. Remove chain bar clamp nuts (15).
2. Remove the side case (16). (Fig. 8)
15
English
13
9
12
11
10
Fig. 6
Fig. 7
16
Fig. 8
7