Pause - ECOVACS ROBOTICS WINBOT7 Mode D'emploi

3. Operating the Robot
Power ON
2
Move the Power Switch to the "ON" position.
WINBOT 7 is powered ON when it generates
suction.
WINBOT 7's Back-Up Battery must be fully
*
charged before use. Plug WINBOT 7 in, move
the Power Switch to the CHARGE position until
the Status Indicator Light glows a continuous
GREEN.
Place on the Glass
3
Place WINBOT 7 on the window at least 10cm
(4'') from the corners and other obstacles and
press it firmly on the window. WINBOT 7 has
successfully attached to the window when the
Status Indicator Light flashes BLUE.
Please be careful not to pull the Air Release
*
Trigger.
Please ensure there is a 15cm (5.9") clearance
*
between the glass and obstacles in the room like
curtains or furniture.
Start
4
Press the START/PAUSE Button on WINBOT 7
or on the Remote Control to begin cleaning.

3.8 Pause

Pause WINBOT 7 during cleaning by pressing
the START/PAUSE button on the robot or on the
Remote control.
10 10
EN