Directions For Use - Sacopa TigrusELEC Manuel D'installation Et D'entretien

5. START-UP
IMPORTANT: do not allow swimming when the TigrusELEC is in the pool.
5.1 Connect the power supply to 230V
~AC and then push the button
the ON/OFF circle will light up.
5.2 Next, the 1h, 2h, 3h and 4h will light up sequentially.
5.3 To select the number of hours you want the TigrusELEC to be working cleaning
your pool, just press the SET button when the circle of the number of hours you
want it to operate lights up.
5.4 To turn off the TigrusELEC before the programme ends, just press the
button.

6. DIRECTIONS FOR USE

By using the TigrusELEC as often as possible, you will fully enjoy a constantly clean pool and the tank of the TigrusELEC will fill up less
frequently.
The TigrusELEC must be used in pool water with the following characteristics:
DO NOT LEAVE THE TigrusELEC PERMANENTLY IN THE WATER
Unrolling the TigrusELEC cable
When you see that the electric cable is very tightly rolled up, take the TigrusELEC out of the water and change the position of the directing unit,
which you will find on the front part of the TigrusELEC, the directing unit is next to the front wheel. With this you will be able to unroll the cable.
If the directing unit is in position 1, the Tigrus will turn clockwise. And If the directing unit is in position 2, the Tigrus will turn anticlockwise.
,
Chlorine < 2mg/l
pH between 6.8 and 7.6,
Temperature between 0°C and 35°C.
4