English - Wurth Master BS 10-A Instructions D'emploi

OBJ_BUCH-831-001.book Page 10 Thursday, November 27, 2008 8:58 AM
Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious
injury.
❏ See data sheet for further safety warnings
and instructions.
❏ Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance. Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric shock.
❏ Switch off the power tool immediately
when the tool insert jams. Be prepared for
high reaction torque that can cause kick-
back. The tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
❏ Hold power tool by the insulated gripping
surfaces, when performing an operation
where the cutting tool may run into hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
❏ Hold the machine with a firm grip. High
reaction torque can briefly occur while driving in
and loosening screws.
❏ Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
❏ Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from light
alloys can burn or explode.
Intended Use
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal, ceramic
and plastic.
For damage caused by usage other than intended,
the user is responsible.
10–English
For Your Safety
❏ Always wait until the machine has come to
a complete stop before placing it down.
The tool insert can jam and lead to loss of control
over the power tool.
❏ Avoid unintentional switching on. Ensure
the On/Off switch is in the off position
before inserting battery pack. Carrying the
power tool with your finger on the On/Off switch
or inserting the battery pack into power tools that
have the switch on invites accidents.
❏ Do not open the battery. Danger of short-
circuiting.
Protect the battery against heat,
e. g., also against continuous
sun irradiation and fire. There is
danger of explosion.
❏ In case of damage and improper use of
the battery, vapours may be emitted. Pro-
vide for fresh air and seek medical help in
case of complaints. The vapours can irritate
the respiratory system.
❏ When the battery is defective, liquid can
escape and come into contact with adja-
cent components. Check any parts con-
cerned. Clean such parts or replace them, if
required.
❏ Use the battery only in conjunction with
your Würth power tool. This measure alone
protects the battery against dangerous overload.
❏ Use only original Würth accessories.
Product Features
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
The numbering of the product features refers to the
illustration of the power tool on the graphics page.
1 Keyless chuck
2 Torque presetting ring
3 Gear selector
4 Battery unlocking button
5 Battery*
6 Rotational direction switch
7 On/Off switch
8 "Power Light"
9 Universal bit holder*
27.11.08