86
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gramme.
You cannot activate or deactivate the
multitab function when the programme
operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
• Press the multitab button. The multitab in-
dicator light comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab in-
dicator light goes off.
Do these steps if the drying results
are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.
To activate/deactivate the rinse aid dispens-
er:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
Setting and starting a washing programme
Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then
it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press the programme button and select
a washing programme. The digital display
shows the programme number. Refer to
the chapter 'Washing programmes'.
– The programme button indicator light
flashes.
– The phase indicator lights for the wash-
ing programme flash.
4. If necessary, set one or more options.
Refer to the chapter 'Washing pro-
– The indicator lights for function buttons
A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
– The digital display shows the setting.
6. Press function button B again.
– The digital display shows the new set-
ting.
7. Switch off the appliance to save the op-
eration.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
grammes' and make sure that the option
is available with the set programme.
5. Close the door.
– The washing programme starts auto-
matically.
– The phase indicator lights go off but not
the indicator light of the phase in oper-
ation.
– The programme button indicator light
is on with a static light.
– The digital display shows the duration
time of the washing programme.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Rinse aid dispenser de-
activated
Rinse aid dispenser ac-
tivated