Use Of The Appliance - Schulthess Perla SG 55I Notice D'utilisation

78
• The number of the washing programme.
• Remaining time to the end of the pro-
gramme.
• Activation/deactivation of the rinse aid dis-
penser (only with multitab function on).
• End of the washing programme. The dis-
play shows a zero.
• Number of hours in delay start.
• Fault codes.
• Activation/deactivation of the audible sig-
nals.
Function buttons
Use the function buttons for these opera-
tions:
• To set the water softener. Refer to the
chapter 'Setting the water softener'.
• To deactivate/activate the rinse aid dis-
penser, when multitab function is active.
Refer to the chapter 'Multitab function'.
• To cancel the washing programme or the
delay start in progress.
• To deactivate/activate the audible signals.
Setting mode
The appliance must be in setting mode for
these operations:
• To set a washing programme.
• To set the water softener level.
• To deactivate/activate the rinse aid dis-
penser.
• To deactivate/activate the audible signals.
Press the on/off button. The appliance is in
setting mode when:
– The programme button indicator light
comes on,
– the digital display shows 2 horizontal bars.
Press the on/off button. The appliance is not
in setting mode when:
– The programme button indicator light
comes on,
– the digital display shows the time duration
of a washing programme.
– A washing programme is set. It is neces-
sary to cancel the programme to go back

Use of the appliance

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
to the setting mode. Refer to the chapter
'Setting and starting a washing pro-
gramme'.
Audible signals
You can hear an audible signal:
• At the end of the washing programme.
• During the setting of the level of the water
softener.
• When the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible sig-
nals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons A and B.
5. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
The audible signals are activated.
6. Press the function button C again.
– The digital display shows the new set-
ting.
The audible signals are deactivated.
7. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
display shows necessary setting.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.
5. Set the correct washing programme for
the type of load and soil.
Audible signals deactiva-
ted
Audible signals activated