JVC KD-X560BT Guide De Démarrage Rapide page 12

Installation
Ñ Removing the trim plate
1) Use the extraction key (accessory 4) to lever out
the four tabs (two on the top part, two on the
bottom part).
2) Pull the trim plate forward.
Ñ Removing the unit
1) Remove the trim plate by referring to step 1 in
"Removing the trim plate".
2) Detach the faceplate.
3) Insert the two extraction key (accessory 3) deeply
into the slots on each side, as shown.
3
4) Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
✎
NOTE
• Be careful to avoid injury from the catch pins on
the extraction key.
5) Pull the unit all the way out with your hands, being
careful not to drop it.
12
4
1
2
Ñ Connecting wires to terminals
Accessory 7
Accessory 6
Blue
(Power control/ Antenna control wire)
to the power terminal for the booster
amplifier of the film-type or short pole
type antenna. (Max. 150mA, 12V)
*1 If no connections are made, do not
let the cable come out from the tab.
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) ¤
(To car chassis)
Speaker impedance: 4-8 Ω
White
To front left speaker
White/Black
Gray
To front right speaker
Gray/Black
Green
To rear left speaker
Green/Black
Purple
To rear right speaker
Purple/Black
1 3 5 7
2 4 6 8
1 3 5 7
2 4 6 8
*
1
Connect either to the power
control terminal when using
the optional power amplifier, or
Ignition key switch
ACC
B+
Car fuse box
Battery