Module Configuration; Set The Wifi Module To Default Settings - Elinchrom EL-Skyport RX WiFi Manuel D'utilisation

MODULE CONFIGURATION

SWITCH MODULE TO SPEED SYNC MODE OR BACK NORMAL SYNC MODE:
When the WiFi module is connected to iPhone™, iPad™ or iPod Touch™, the settings can be controlled or changed in the EL-
Skyport RX WiFi Remote App. Press the SETTINGS symbol (wheel) in the application to change the sync modus.
Only when used as a "Universal Receiver" to trigger flashes, settings can be changed to SPEED SYNC or NORMAL SYNC mode
directly on the WiFi module
Note:
In case the NORMAL SYNC mode should be changed to e.g. SPEED SYNC mode, all other EL-Skyport Transmitter Speed and
all EL-Skyport Speed Receivers, if built-in versions or the Universal Speed Receiver must have the same SPEED SYNC settings,
otherwise flashes cannot be triggered. Older, "non SPEED" EL-Skyport Transmitter, Universal Receivers or Transceiver RX
modules do not offer the SPEED SYNC mode.
1. Switch module ON and wait approx. 5 seconds.
2. Press and hold ON button for 5 Seconds until Status LED flashes.
3. Release the ON button.
4. Now the module is switched to SPEED SYNC mode and the status LED flashes twice approximately every 3 to 4
seconds.
5. To switch back to NORMAL SYNC mode repeat step 2 and 3.
6. Now the module is switched to NORMAL SYNC mode and the status LED flashes once approximately every 3 to 4
seconds.

SET THE WIFI MODULE TO DEFAULT SETTINGS

1. Switch module ON and wait approx. 5 seconds
2. Press and hold ON button for 10 Seconds until Status LED flashes multiple times
3. Release the ON button
4. Now the module is switched to DEFAULT settings
• EL-Skyport sync mode = Normal Sync
• Trigger impulse width of 80 milliseconds (12 frames per second)
• Auto Off Time = 1 hour
• Auto Off = On
• WiFi Password = Off
8