Status Led - Elinchrom EL-Skyport RX WiFi Manuel D'utilisation

On/Off & Mode Button:
EL-Skyport Antenna:
SYNC Socket:
Charge Socket:
RESET Button:
LED

Status LED:

WiFi LED:
Data LED:
Press once to switch the module ON or OFF. After switching ON, the module needs
approx. 5 Seconds to set up the WiFi connection. See module configuration for the
different module modes.
Turn-around antenna to get best possible distance range performance.
The EL-Skyport WiFi module can be used as a EL-Skyport Universal Receiver module.
All configurations can be applied by using the Mobile App.
Max. SYNC Voltage = 50 VDC
DC 5V/500mA battery charge input socket for the Elinchrom EL-Skyport multi-voltage
charger only.
Use only if the EL-Skyport RX WiFi module does not switch ON or OFF anymore. This will
also RESET the WiFi password to default value!
Shows the actual status of the Module (same as Universal Module)
• ON when the battery charges.
• Flashes once every 3 - 4 seconds in NORMAL SYNC mode.
• Flashes twice every 3 - 4 seconds in SPEED SYNC mode.
• Flashes fast after pressing the ON button 5 s to change from NORMAL to SPEED
SYNC mode.
• Flashes fast multiple times after pressing the ON button 10 s to switch back to
DEFAULT settings.
• Flashes fast multiple times after pressing the ON button 15 s to enable the
FIRMWARE UPDATE mode.
• Blinks when WiFi module is configured, but NOT connected.
• ON when WiFi is connected to your Apple
Shows that the WiFi data transfer between your Apple
WiFi module is active.
device and is ready for Data transfer.
®
device and the EL-Skyport RX
®
EN
11