Control Panel; Making Ice; Cleaning, Care & Maintenance - Polar G620 Mode D'emploi

UK
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning the ice maker, maintain
a distance of 20cm (7 inches) between the
appliance and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
3. If necessary, adjust the screw legs of the ice
maker to make it level. The efficiency of the
ice maker can be reduced if the appliance is
unevenly located.
Operation

Control Panel

Ice cube size indicator

Making Ice

Note: Before using for the first
time, clean the water tank, ice
basket and ice basket shelf.
Each time the appliance is refilled, the first
ice making cycle is used to reduce the water
temperature. This results in uneven ice cube
production which is perfectly normal. You may wish
to discard ice created in the first production cycle.
4
1. Lift the access lid and fill the water tank up the
level of the ice basket shelf.
2. Connect the appliance to the power and press
the START button.
3. Press the SELECT button repeatedly to scroll
through the ice cube sizes. Stop when the
required size is illuminated.
Note: Each ice making cycle
takes between 6-12 minutes,
depending on the size of cube
selected.
4. The appliance will run a start-up routine and
then begin ice production.
Note: If the water level is too
low, the Water Low indicator
lights up and the appliance
stops working. Fill the water
tank and the appliance will
restart automatically.
5. When the cubes reach the ice sensor the
appliance will stop production. Production
resumes once ice has been removed.
6. Press the STOP button at any time to halt the
ice making process.
Cleaning, Care &
Maintenance
• Always switch off and disconnect the power
supply before cleaning.
• Warm, soapy water is recommended for
cleaning. Cleaning agents may leave harmful
residues. DO NOT wash the base unit, instead
wipe the exterior with a damp cloth.
• A POLAR agent or qualified technician should
carry out repairs if required.
• Clean the water filter regularly with a small
brush, particularly in hard water areas. The
water filter is located in the pump inlet at the
bottom of the water tank, remove by pulling
out with fingers.
• If the appliance is to be left unused for longer
than 24 hours, loosen the drain screw and
drain the water from the tank.
• The inner removable parts and water tank
should be cleaned regularly.