Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
erate using suction only, e.g. when
moving from carpeting to an area rug,
for example.
Disconnecting the
Electrobrush (Fig. 11)
Press the release button and pull the
suction tube out of the Electrobrush
connection socket.
Multi-function indicator light
The indicator light on the Electrobrush
lights up yellow to let you know that the
Electrobrush is switched on.
Frequently asked questions
The multi-function indicator light is lit
up red
The red light indicates a roller blockage,
e.g., as a result of a large item being
vacuumed up.
Turn off the vacuum cleaner and un-
plug it.
Remove the blockage.
Press the indicator light.
This resets the blockage sensor.
Reconnect the vacuum cleaner and
switch it on.
The Electrobrush switches itself off
The indicator light still lights up yellow.
The overheating protection mechanism
has been activated due to overheating
or a blockage.
Turn off the vacuum cleaner and un-
plug it.
Check the vacuum cleaner for any
blockages and check all the filters in
the vacuum cleaner.
The Electrobrush has to cool down. To
speed up this process:
Reconnect the vacuum cleaner to the
power supply and switch it back on
together with the Electrobrush.
Raise the connection socket to the
upright position.
The Electrobrush will be ready for use
again after about ten minutes.
Maintenance
Removing threads and hairs (Fig. 12)
Use a pair of scissors to cut any
threads or hairs that have wound
themselves around the roller brush.
To guide the scissors, move along the
guide track in the roller.
Then, run the vacuum cleaner to vac-
uum up the cut pieces.
en-US
7
Publicité
Table des Matières
