Technical Data - Dupla CO2 Armatur Smart Mode D'emploi

pre-set operating pressure will adjust to the operating pressure marked "Optimal" when the
stainless steel fine needle valve 1 opens. Each time the cylinder is changed, the flat seal
union nut must be checked and if there is even the slightest damage or wear, it should be replaced.
The CO Pressure Regulator Smart is equipped with an integrated swing check valve which protects
2
the Pressure Regulator from a backflow of water.
1
1a
4
3
6 7
6
7 on the
2
5
Connection Solenoid Valve Pro:
Connection of a CO Solenoid Valve Pro (art.-no.: 80243). For semi or fully automatic regulation,
2
you can retrofit a CO Solenoid Valve. The CO
2
Pressure Regulator and the fine needle valve. Remove the fine needle valve from the Pressure
Regulator. Then connect the fine needle valve with the connecting screw of the CO
Pro 8 . It is essential to wrap the outer thread of the connections with 4 – 5 layers of Teflon tape
9 (included with product) before assembly to ensure a complete seal. Then screw the fully assembled
CO Solenoid Valve Pro 10 + 11 into the Pressure Regulator. Align the CO
2
check the tightness of the screw connections!
8 9
10 11
Replacement seal:
Art. no.: 80212 Flat seal CO Pressure Regulator Smart
2

Technical data:

Gas type: CO , Connection thread W 21.8
2
Operating pressure pre-set: 1.5 bar
Manometer connection 1 x 1/8 inch, ISO 7 (DIN 2999)
Valve spindle: Stainless steel
Connections: Outlet for CO hose
2
Microfilter: 2 units installed:
Solenoid Valve Pro 1a is screwed between the
2
Solenoid Valve
2
Solenoid Valve Pro and
2
Material: Brass nickel-plated:
Weight: approx. 670 g
Technical details subject to change.
Illustrations are non-binding.
Flat seal CO Pressure Regulator Smart
2
(art.-no.: 80212)
7