Krushr F86/600 Guide De L'utilisateur page 17

of compaction may tear a weaker bag. Furthermore, an oversized or undersized
bag will make it more likely that the bag will become trapped in the crushing
mechanism potentially requiring a service engineer visit. Please note that where
a non-Krüshr bag is used which gets trapped inside the compaction mechanism,
any resulting call out or damage to your appliance is not covered under your
guarantee.
1. Remove the bin from the supporting cage noting how the top rim of the
bin rests on the rollers at the top of the cage.
2. Unfold a bag noting how the bag is shaped to fit the bin.
3. Lower the bag into the bin folding between 15 cm
- 20 cm over the top of the bin. This will ensure that the
bag does not fall into the bin during operation and leave
enough excess at the top to secure fitment around the
rim of the bin. It is important that the bag inside the bin
is not too tight so as to allow for compaction of the
waste without tearing the bag
4. Once the bag is inserted, lower the bin back into
its supporting frame pushing the overhanging 15 cm –
20 cm of bag down between the outer edge of the bin
and the supporting cage. It is important that the bag is
pinched between the lower side of the rim of the bin
and the rollers on which it rests.
PLEASE NOTE that ONLY once the bin is at least two thirds full should you press
the blue button to compact the waste. Failure to adhere to this requirement
makes it more likely that the bag becomes trapped in the mechanism.
KRUSHR BAGS available from your local dealer or visit www.Krushr.com
17
UK/Fr