Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Modern faucets and shower products utilize a combination
of materials to comply with the needs of the market with
regard to design and functionality.
To avoid damage,it is necessary to use some caution when
cleaning.Damage caused by improper treatment is not cov-
ered under the warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale,use only products made specifi-
cally for that purpose.Always follow the manufacturer's
instructions when using.
• Do not use cleaners that contain hydrochloric,formic,
acetic,or phosphoric acids,as these will cause consid-
erable damage to finishes and to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives.Do not use
abrasive cleaning cloths,pads,or sponges.
Problem
Limited water flow
Crossflow, hot water being forced
into cold water pipe, or vice versa,
when mixer is closed
Output temperature does not
correspond with temperature set
Temperature regulation not possible
Safety stop override button not
operating
Shower drips continuously
Manufacturer's Limited Warranty:
• This product has a one year manufacturers warranty.
• The warranty period begins upon date of product purchase as specified in your sales receipt.
Manufacturer will repair or replace at its sole option issues relating to product defect or production
related issues as can be reasonably determined.
• Damage or issues that arise due to mishandling or misuse of the product outside its intended
purpose will void the warranty.
• Any claims need to be supported by the original purchase documents such as official receipt or
proof of purchase reflecting date, product purchased and store/sales channel.
Cleaning Recommendations
Troubleshooting
Possible Causes
- Supply pressure inadequate
- Filters Gasket are dirty
- Check valves dirty or leaking
- Thermostat has not been adjusted
- Hot water temperature too low
- Temperature regulator dirty or
calcified
- Spring defective
- Button calcified
- Dirt or sedimentation on valve seat,
shut-off unit damaged
Cleaning Procedures
• Required cleaning your faucets and
regular cleaning will prevent scale buildup and water
spotting.
• Follow the label instructions.Do not allow any cleaner to
remain on the product for longer than necessary.
• When using spray cleaners,Please spray first to a sponge
or cloth,Don't spray directly to the product.
• Please use clean water to rinse to remove residual cleaners
and dirt.
Important
• Soap and shampoo residue can also cause damage to
the product.Rinse with clean water after use.
• If the surface is already damaged,harsh cleaning mate-
rials will cause further damage.
- Check water pressure (If a pump has
been installed check to see if the
pump is working)
- Clean Filter Gasket between shower
and hose
- Clean check valves,exchange if
necessary
-
Adjust thermostat(
supplier)
- reset high temperature limit stop
- Clean temperature regulator,
exchange if necessary
- Clean spring /button, exchange if
necessary
- Clean or exchange shut-off unit
English
shower products
,
Remedy
please contact the
13
Publicité
Table des Matières
