Marmitek GIGAVIDEO 40 Mode D'emploi page 5

manual_giga40 12-04-2002 11:06 Page 5
the jack [E] to the 12V jack at the backside of the receiver. Only use the supplied mains adaptor!
4. Switch the Power switch [B] to the ON position.
5. Set the Channel-switch [A] on A.
6. Put the side antenna [J] of the remote control extender in an upright position.
3. FINE TUNING YOUR MARMITEK GIGAVIDEO SET:
Make sure your A/V equipment is switched on. Switch the receiving TV on and select the A/V
channel (normally found on the "0" or "AV" button). The picture should now automatically be there,
no tuning is required.
The wireless GigaVideo usually works best with the indented faces of the antennas [K] on the
Transmitter and Receiver unit look at one another. Sometimes however distance, reflections and
other effects in the home may affect the signal so that some adjustment of either Transmitter or
Receiver antenna may be necessary to get the best signal.
If still experiencing difficulty, try changing the "ABCD" channel selector and change channels.
Remember though both the receiver and transmitter must be on the same channel.
If you are not getting any signal at all:
Check that the units are connected to mains and that the Power-switch is in the ON position. Check
that the Channel slide switch (labelled A-D) on both GigaVideo units is set at the same number.
Check if the receiving TV is on the correct A/V channel. Raise the small black side antenna [J] to an
upright position.
4. THE REMOTE EXTENDER FEATURE:
Your Marmitek VideoSender has the ability to transmit infrared signals from your own remote
control from your receiving TV back to the equipment connected to videosender. For example, you
can change channels on your satellite receiver while viewing in another room. Simply point your
original remote control to the IR window on the front of your GigaVideo Receiver. The IR signal is
now transmitted by radio to the GigaVideo transmitter.
Set up is simple, ideally with 2 people. Locate the mini IR emitter (the only item left now) and
connect the small jack plug on the back of the Receiver (IR)
You have to place the IR transmitter LED in front of the IR sensor of the equipment you want to
control. For the best result you can experiment which position of the IR transmitter LED works best.
If you have problems with the range, try to move the receiver and/or transmitter away from your
connected equipment. This can greatly increase performance of the radio transmission.
Copyright © Marmitek X-10. The right is reserved to make technical modifications
GIGAVIDEO 40 5