Marmitek GIGAVIDEO 40 Mode D'emploi page 4

manual_giga40 12-04-2002 11:06
Connecting the transmitter to your VCR or Satellite receiver, allows you to choose channels
independent from your main TV. If the jacks are colored differently, connect the yellow plug on the
jack VIDEO, the red plug on the jack AUDIO RIGHT and the white plug to the jack AUDIO LEFT.
3. Switch the Power slide switch on the side into the "OFF" position
4. Plug the supplied mains adaptor, labelled Sender/Transmitter 200mA, into a 230Volt -50Hz
wall outlet and connect the jack to the 12V jack at the rear side of the transmitter. Only use
the supplied mains adaptor!
5. Switch the Power switch to the ON position.
6. Set the Channel-switch [A] on A.
7. Position the transmitter in a convenient location and orient the antenna [K]
If you have several A/V components:
If you have two or more A/V components (e.g. VCR, Cable box, Laserdisc or satellite receiver) that
you want to watch in another room, they will probably already been hooked up to the local TV in
series. To connect the GigaVideo Transmitter you just need to indentify the last component in the
chain and connect the Line OUT or scart to the GigaVideo Transmitter IN jacks.
2. SETTING UP THE MARMITEK GIGAVIDEO RECEIVER:
1. Connect a set of Audio/Video cables to the LINE OUT jacks [H+I] of your GigaVideo Receiver.
Connect the other end to your TV. If your TV has a Scart connector, you may use the
Scart adaptor provided; labelled: "Receiver".
2. Switch the Power slide switch on the side into the "OFF" position
3. Plug the supplied mains adaptor, labelled Receiver 500mA, into a 230Volt -50Hz wall outlet and connect
4
Page 4
GIGAVIDEO TRANSMITTER
SCART ADAPTER
"TRANSMITTER"
MARMITEK