®
Bluetooth
In addition to the six audio inputs on the rear panel, you can send an audio signal wirelessly
through Zonetech to any zone using Bluetooth. This signal uses its own input channel.
IMPORTANT: Bluetooth and WiFi may not both be in use at the same time. When Bluetooth is
enabled, WiFi will be disabled.
To pair/connect your Bluetooth device to Zonetech:
1.
On Zonetech, press the Stream button to access the Stream settings.
2.
Use the Left/Right (/) buttons to select the Stream Source (Source) setting. Then,
turn the Info knob to select the Bluetooth option.
3.
Use the Left/Right (/) buttons to select the Bluetooth Pairing (Pairing) setting. Then,
turn the Info knob to select Enabled. Zonetech's Stream Light will begin flashing.
4.
On your Bluetooth device, enter its Bluetooth settings, find Zonetech and connect to it.
The Stream Light will be solid blue when it is connected.
Notes:
•
If your device requires a passcode or PIN, enter 0000.
•
If your Bluetooth device is not able to connect to Zonetech, set the Stream Source
(Source) to None to disconnect previous Bluetooth connections, and try the above steps
again.
•
If you experience trouble connecting or playing music, make sure your Bluetooth device's
operating system is up to date.
To unpair/disconnect your Bluetooth device from Zonetech, set the Stream Source
(Source) setting to None. Zonetech will disconnect from your Bluetooth device. Alternatively,
disconnect using the Bluetooth settings on your device.
To stream the Bluetooth audio signal to an output on Zonetech:
1.
On Zonetech, press the Stream button to
access the Stream settings.
2.
Follow the directions
Bluetooth device to Zonetech.
3.
Press and release the Zone button (1–6) for the
zone where you want to send the Bluetooth
audio signal.
4.
Use the Left/Right (/) buttons to select the
Input Source (In Source) setting.
5.
Turn the Info knob to select the Stream
option. That zone is now receiving the audio
signal from your Bluetooth device.
above
to pair your
7