Rane ZONETECH Guide D'utilisation page 6

Operation
Editing Input Settings
You can use Zonetech's display, Left/Right (/) buttons, and Info knob to edit the settings
of each input.
To select an input to edit, press the corresponding Input button (1–6) or the Stream
button. The display will indicate which input is selected: Input 1–6 or Stream.
To show the previous or next setting for the selected input, use the Left/Right (/)
buttons (respectively). Turn the Info knob to adjust the value of each setting.
Note: To control the input settings remotely, you can also use a web-based interface
on your computer (connected to the Computer Ethernet port), or up to two Rane DR6
master remote controls (connected to the Master Remote and Pager port).
These are some of the editable input settings which are most commonly used. The
abbreviated name (shown when the setting is not selected) is in parentheses.
Note: For the complete list of settings shown in the display and their functions, download the
full User Guide.
Input Level (Level)
This is the volume level at the input stage: -88.0 to
+12.0 dB.
Tip: If you are unsure of what this level should be,
it is better to use a lower setting to allow for
headroom and to prevent clipping/distortion.
For each input, you can also adjust the Low Shelf,
PEQ, and High Shelf settings.
Input Type (Type)
This is the type of device connected to Input 5
and Input 6: Dynamic (microphone), Condenser
(microphone), Unbalanced Line+, Balanced Line
(default: Balanced Line).
Note: Phantom power is enabled only when
Condenser is selected.
Tip: Unbalanced Line+ sums two unbalanced
signals (such as left and right RCA lines) when one
is connected to the positive (+) input and one is
connected to the negative (-) input.
Tip: Balanced Line is a typical fully balanced line-
level input (e.g., TRS or XLR) as used with
commercial audio equipment.
Stream Source (Source)
This is the source from which Zonetech will play
streamed audio: None (off), Bluetooth, AirPlay,
UPnP/DLNA.
6
(Inputs 5 and 6 only)