Use And Installation Instructions; Inner Lining; Chin-Wind Deflector; Snap-Fastener System - Crivit 272278 Notice D'utilisation

Use and Installation
instructions

Inner Lining

The inner lining (13) can be completely removed
and cleaned separately (see care instructions) .
To remove the inner lining, firstly remove the
helmet collar and the cheek pads . Then undo the
back press-studs of the inner lining and pull the
clips of the inner lining from the front side of the
helmet (see Fig . C) .

Chin-Wind Deflector

The chin wind deflector (10) is secured to the
pivoted piece by means of snaps .
This can be removed and re-attached as required
(see Fig . E) .

Snap-Fastener System

The snap-fastener enables an individual and
quick vernier adjustment of the chin strap .
Press the snap-fastener together until the helmet is
sitting comfortably but firm (see Fig . D) .
The movable buckle may be used to fasten or
secure excess chin strap .

Sun Shield

The integrated sun shield (8) will enable you to
quickly and easily react to changed light condi-
tions with the aid of the patent mechanism .
To pull out and retract the sun shield, press the
safety latch to operate the slider (4) (see Fig . B) .
Note:
• Please take care that the edge of the sun shield
does not block your field of vision .
• The sun shield may only be used when the
visor is closed and may only be used during
the day .

Cheek Pads

You will receive two different pairs of cheek
pads (12) for individual size adjustment .
The thinner cheek-pads are already pre-mounted
as standard . The thicker cheek pad is enclosed
with the helmet separately .
If the helmet is too loose and therefore is not sit-
ting firmly on your head, you can replace the thin
cheek pad with the thicker ones .
The cheek pads are affixed via three press-studs
respectively in the helmet . You can easily remove
the pads (see Fig . F) . The thicker cheek pads
can now also be affixed in the helmet with three
press-studs . You need to be able to hear that
each press-stud locks-in .

Acoustic Damping

The acoustic damping (11) is for noise reduction,
in particular when driving at high speeds .
Press the acoustic damping into the cavity of the
cheek pads (see Fig . G) . The acoustic side pad
equipped with Velcro faces towards the helmet
shell .

Front Vent

The front vent (5) can be opened and closed by
means of a slider (see Fig . H) .

Top Vent

The top vent (1) can be opened and closed by
means of a slider (see Fig . I) .
GB 9